Instructions
STEP 1:
Print patterns.
STEP 2:
Assemble beads on pegboard according to patterns.
STEP 3:
Place ironing paper over beads and iron for about 10 seconds, moving iron in a circular motion. DO NOT OVER IRON! If the beads melt too much, the pieces will not snap together and you will not be able to assemble the holder Let cool. CAUTION: Fusing the beads with an iron requires adult supervision! Make sure the iron is NOT on the steam setting before beginning.
STEP 4:
Remove bead work from pegboards; turn over and with ironing paper on top, iron again for just a few seconds.
STEP 5:
Once all pieces are cool, snap sides into bottom section at interlocking joint areas.