Create this simple throw pillow that incorporates a cross stitch pattern, some sparkling jewels and a no-sew technique.
Instructions
STEP 1:
Complete cross stitch pattern according to package directions.
STEP 2:
Fold excess cross stitch fabric to back of piece and press flat.
STEP 3:
Glue fringe to front edges of cross stitch piece and allow to dry.
STEP 4:
Snip connector loops from jewels and stitch to piece as shown using silver thread.
STEP 5:
Cut Heat N Bond to size of cross stitch piece and apply to back according to directions.
STEP 6:
Cut square pieces of fleece 10 inches larger than size of pillow form. Iron cross stitch piece to center of one fleece square, using a pressing cloth for protection.
STEP 7:
Lay fleece squares on top of each other and at 1 inch intervals, cut 3 inch long slits along all four sides. See downloadable template. To ensure ties are all the same length and size, you may want to create a chipboard template to use as a guide. Cut and discard square corner sections.
STEP 8:
Sandwich the pillow form between both fleece layers and tie corresponding fringe pieces together in a square knot.