You can make these great coasters and impress guests with each use. They are simple to make yet they look like they took you hours to create!
Instructions
STEP 1:
Remove magnets from photo holder, measure from “bent” edge 3 ½ inches and using ruler and knife, score about 4 times, carefully bend the small edge and it should “snap” on your score, then score lower layer again 4 times, carefully bend back and it should snap ~ this creates a square
STEP 2:
Cut your pencil by number into 3 ½ inch squares with your paper trimmer and set aside
STEP 3:
Cut 3 ½ inch strips on felt with your paper trimmer, slide into photo holder and use knife to cut along edge to fit perfectly to photo holder
STEP 4:
Remove the felt and glue pencil by number square to felt and slide back into holder.
STEP 5:
Glue felt onto back and use knife to cut on edge again to get perfect match
STEP 6:
Repeat for remaining coasters.
STEP 7:
Tie ribbon around coasters. If edge of “snap” is not smooth to the touch, you can lightly sand with sandpaper