String sliders and beads to create a bracelet that draws the eye with its changing looks – from one to two strands, solid silver to delicate crystals and pearls, it combines into a harmonious whole.
Instructions
STEP 1:
Cut the beading wire into two 9 inch pieces. Put a bead stopper or tape on one end of each strand one inch from the end.
STEP 2:
String one 4mm bicone on each strand. String one 6 mm pearl over both strands.
STEP 3:
String one 4 mm bicone on each strand. String one 6 mm bicone on each strand.
STEP 4:
String the two strand slider over each strand. String one 6 mm bicone on each strand.
STEP 5:
String one 4mm pearl on each strand. String one 6mm bicone over both strands.
STEP 6:
String one 4 mm pearl on each strand. String one 6 mm bicone on each strand.
STEP 7:
String the two strand slider over each strand. String one 6 mm bicone on each strand.
STEP 8:
String one 4 mm bicone on each strand. String one 4 mm bicone over both strands.
STEP 9:
String the large star bead over both strands.
STEP 10:
Repeat steps 8 through 2 in reverse order.
STEP 11:
String a crimp tube on each strand. Pass one strand of beading wire through each hole in one half of the closure.
STEP 12:
Pass each strand of beading wire through the other hole and the crimp tube. Pull the wire snug and crimp the tube on each side.
STEP 13:
Remove the tape or bead stopper and repeat steps 18 through 21 with the other half of the closure.