When I’m going to a Spring or Summer evening get together, adding a little sparkle to my outfit is always fresh. I love the way the little cube boxes add a special accent to this simple ankle bracelet.
Instructions
STEP 1:
Cut a piece of wire the width of your ankle plus 2 inches. Generally about 10 inches should be enough.
STEP 2:
At one end of the string attach a spring to hold the beads strung in place.
STEP 3:
Thread on the beads, one Crystal, Lt Sapphire Chrysolite, Lt Siam, Lt Sapphire and Crystal.
STEP 4:
Thread on one Lt Siam cube dangle and Crystal bead.
STEP 5:
Thread on the beads, one Lt Sapphire Chrysolite, Lt Siam, Lt Sapphire and Crystal, Lt Sapphire and Crystal.
STEP 6:
Thread on Lt Sapphire cube dangle.
STEP 7:
Follow the order of the crystals in the picture until you reach the end.
STEP 8:
Add a crimp to the end and 1 crystal.
STEP 9:
Loop the string around the toggle and go back through the crystal, crimp and 2-3 crystals.
STEP 10:
Use a crimp tool and crimp the bead.
STEP 11:
Release the other end of the string held by the String Spring and add a crimp and a crystal.
STEP 12:
Loop the string around the toggle and go back through the crystal, crimp and 2-3 crystals and pull the string to adjust the tension and make sure you’ve taken up the slack in the string.
STEP 13:
Use a crimp tool and crimp the bead.
STEP 14:
Clip off any excess string.