Instructions
STEP 1:
Using the wire cutters cut a piece of 20 gauge wire approximately 20” long.
STEP 2:
Add approximately 6” of beads to the wire, leaving about 2” on one end. Fold the short end of the wire out at a 90 degree angle to prevent the beads from falling off as you work on the other side.
STEP 3:
After you have added all the beads, twist the wires around several times. Make sure the twists are as close the crystals as possible.
STEP 4:
Wrap the two wires around a glass votive candle holder to meet up with the other side of the beaded handle.
STEP 5:
Wrap the 4 wires around each other and cut any excess wire away.